- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I try to program PSoC101-049-CY8CKIT-049-42xx by Bootloader Host in PSoC Creator,but the log show the followings:
09:23:55 PM - Selected device: USB Serial Port (COM4) - UART
Generic Serial Port
09:23:58 PM - program Started
09:23:59 PM - The operation has timed out.
09:23:59 PM - The bootloader reported error 'Unknown error '0x38' occurred in the bootload process.'.
09:23:59 PM - program failed in 1002 ms.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check in device manager for com ports, on my PC it is a quite higher number.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had the same problem...
I had my created my own bootloader which gave me these errors. I then loaded the example bootloader project from the zip file in the like below.
I tried using the Bootloader host tool in the PSoC creator 4 and it work after using the UART_Bootloader project and it worked fine.
also make sure that you have your application start the bootloader process. (use Bootloadable_Load(); )