- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I have been using the PSoC 4 M-Series Pioneer Kit for a while without any problems. Now I'm having trouble connecting to the board. When I try to enter Debug mode it gives me an error saying the "Port Acquire Failed". I have rebooted my laptop several times and have tried different USB ports. When I plug the board into the USB port it does power on and runs the last program I executed.
Has anyone had this trouble or may have some suggestions on how to connect to the board, if so please let me know.
Thanks,
Joe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Here is the screen shot of the error message.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try pressing the reset button for more than 10 seconds to change the kitprog's mode. See kitprog manual.
Happy 2017!
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
HI and Happy New Year to you too. I found my problem. It was a driver problem. I reinstalled the drivers and everything is okay.
Thanks,
Joe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Could you please create a new thread ?
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello! I have the same problem now.Could you please tell me where you get the drivers?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The drivers come with PSoC Creator I believe, so it would be in the install files with it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, I will try to install this once again.