Anonymous
Not applicable
Nov 28, 2016
06:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 28, 2016
06:49 AM
Hi all,
I have a brief question concerning the design of mutual capacitance sensors as described in this section, p.116:
http://www.cypress.com/file/46081/download
As shown in Figure 6-8, the button consists of two RX electrodes connected to one another. However, it does not mention (if I have not missed anything), how the TX electrodes are connected. Is it done by routing the traces to the PSoC and connecting these at the pin or is it done by vias underneath the other RX electrodes?
Thanks.
Regards
Solved! Go to Solution.
1 Solution
Dec 01, 2016
12:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 01, 2016
12:49 AM
Hi,
It is done by routing traces underneath the RX electrode through via.
Thanks,
Yuva.
1 Reply
Dec 01, 2016
12:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 01, 2016
12:49 AM
Hi,
It is done by routing traces underneath the RX electrode through via.
Thanks,
Yuva.