Anonymous
Not applicable
Jan 05, 2017
03:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2017
03:20 AM
Hi,
What will be the default state of CX3 GPIOs during reset and post-reset? Can you please share any reference documents regarding this?
1 Reply
Anonymous
Not applicable
Jan 05, 2017
09:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2017
09:35 PM
The pins status will be similar to those of the FX3 during boot. The pins number & functionality may change, but the pin status will be based on the pin functionality and the selected boot-mode. Please check the attached doc for FX3 (table 31) http://www.cypress.com/file/201991/download
After the boot, the status will depend on what you set the GPIO value to be (i.e. it will be firmware controlled).