Anonymous
Not applicable
Jan 06, 2017
09:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 06, 2017
09:18 AM
On the schematic for the FX3 DVK device board (REV - 3.0) The connections between the FX3_121_Bump and the Micro Type B connector have the connections for SS_RX_P and SS_RX_M reversed (Page 9). Positive goes the Minus and Minus goes to positive. Is this an error?
Thanks in advance for your help!
Brandon
2 Replies
Anonymous
Not applicable
Jan 08, 2017
11:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 08, 2017
11:28 PM
USB3 Tx and Rx signals support polarity swapping to give the designer more layout flexibility. No Additional firmware or other changes is needed. The polarity is detected automatically during SS Link training
Anonymous
Not applicable
Jan 09, 2017
06:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2017
06:48 AM
Thank-you for the information! I missed that in the documentation.
Have a nice day!
Brandon