Anonymous
Not applicable
Jan 19, 2017
01:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 19, 2017
01:13 PM
Hello,
Is there any pin muxing capability on the CY7C65215 for the TX and RX pins? Just in case some electrical engineer happens to connect the TX and RX backward and doesn't catch it before the boards get fab'ed.
I know its a long shot, but its easier then lifting legs and adding jumpers.
Thanks for any help!
Frank
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Jan 22, 2017
10:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2017
10:59 PM
You cannot switch the RX/TX pins. RX/TX pins are fixed, we do not provide any such option to configure these pins.
1 Reply
Anonymous
Not applicable
Jan 22, 2017
10:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2017
10:59 PM
You cannot switch the RX/TX pins. RX/TX pins are fixed, we do not provide any such option to configure these pins.