- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My application uses both peripheral.name and local name. In my application the device's local name can be changed by the user over the air. But I want a unique permanent peripheral.name assigned to each device at the time of my programing it. My problem is that I cannot reliable program each device's periperal.name with a unique value through the GAP Settings>General>Device name dialog box. The same peripheral.name keeps showing up over and over again on every new device I try to program, no matter what new value I put in the dialog box.
I have not been able to locate peripheral.name in any of the BLE component files either. Can I hard code a peripheral.name at the time of programming each new device? How?
Would completely wiping the flash of each device prior to programing make the GAP Settings>General>Device name dialog box reliably assign a new peripheral.name to each device? If so, how do you wipe the flash?
Thanks.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please have a look at the function CyBle_GapSetLocalName( ).
Thanks,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please have a look at the function CyBle_GapSetLocalName( ).
Thanks,
Hima