- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm using UART (SCB mode) [v3.20] component in CYBLE-012011-00 module and I see that all interrupt option are disabled for this component.
Is it possible Uart reception generates interrupt on this device?
Thanks,
ASier.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ASier,
UART interrupts are supported on this device with this component version. What are your settings in the component configurator for the "Buffers size" and "Interrupt" groups under the "UART Advanced" tab? The following settings should allow interrupts, for example:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ASier,
UART interrupts are supported on this device with this component version. What are your settings in the component configurator for the "Buffers size" and "Interrupt" groups under the "UART Advanced" tab? The following settings should allow interrupts, for example:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you jrow !!
I had not seen that option.
All right. Best regards,
Asier.