Anonymous
Not applicable
Jan 26, 2017
06:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 26, 2017
06:19 PM
Hi,
I would like to read/write from/to the differential SBU lines. Is there a component to translate the differential lines to a serial-type interface ? or do I need to configure it as GPIO and do SW bit banging ?
Thank you!
Jerome
2 Replies
Anonymous
Not applicable
Jan 30, 2017
04:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 30, 2017
04:08 AM
Hi Jerome,
If it is for Display port application then we don't support any such translation.
Jan 31, 2017
06:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2017
06:33 AM
Hi Pati,
Yes it is for DisplayPort.
Is there any hardware limitation you can think of that might stop me from doing so?
I found the following Manchester code decoder for PSoC 3 but it seems like some of the components are not available in CCG3.
http://www.cypress.com/blog/psoc-insiders-blog/manchester-code
Thank you.
Jerome