- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I developed project for CY8C4146AZI-S423 but I cannot write it to flash using SWD programmer Miniprog3, because on the form "Select Debug Target" of PSoC Creator this chip do not shown. If I try to use PSoC Programmer, the same result - fields "Device Family" and "Device" are not accessible. I try to use Bootloader made my project bootable and using SW1 connected to P0[7] and pressed it before powering the device, but "Bootloader Host" of PSoC Creator told me "Unable read data from the target device". My project developed in PSoC Creator 4.0 Update 1 and I am using PSoC Programmer 3.25.0. The previous device I used is CY8C4125AZI-483 and the device successfully programmed via Miniprog3 and Bootloader with the same project.
Is there any way to program CY8C4146AZI-S423 device?
Thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is in the device list for the miniprog -03 . Have you updated the software to the latest versions.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vasily,
It can be problem of the custom PCB if you are using one. Did you check that ? What are the differences between your previous hardware setup and current setup ?
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi VSRS, thanks for the reply, custom PCB is good, I found the problem recently. The difference between my previous hardware was in chipsets. The new one has had the fully clear flash memory. When I write the new chip using C# example from Miniprog 3 examples, the new device became in visual state from all programs. Thanks anyway!