- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cannot find any information on CSX slider design, is a guideline out there? Information on a suitable TX trace and spacing would be helpful.
I have a CY8CKIT-145-40XX and notice that slider design differs from the guidelines found in AN85951 @ pg117.
I would also like to recommend a dedicated sub-forum for CapSense specific questions.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Well yes, that is the PDF I referenced in my post. It however does not go into detail about CSX based sliders, like what is being used in the CY8CKIT-145-40XX Dev Kit.
I am not sure if I should be using the TX dimensions from the button design on pg 116 and mixing with the slider design on pg 117.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Adam,
Currently we don't have definitive information on the design of CSX based slider. It is still in the testing phase at our end that is the reason you don't see any data published.
Please provide us more details of your application,
1.slider requirements(segments, length)
2.over lay you are planning to use
3.Application it is being designed for.
Thanks,
Ranjith
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ranjith,
I have an open case#00329693 if you want to contribute there.
thanks