Inverted Output on TCPWM (STOP) not work

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello,

   

I have problems to setup a TCPWM with inverted Output.

   

I selected in PWM/Output line signal: Inverse output and when PWM is running the Signal is inverted.

   

But when I stop the PWM Port Pin goes LOW, but I need HIGH (also Inverse).

   

Also tried with Output line_n signal (Direct output/Inverse output), but still the same on Stop Port Pin is LOW.

   

Pull-up Resistor activated still also has no effect.

   

Regards,

   

Michael

0 Likes
4 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

As usual:

   

Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.

   

Datasheet says : line_n is inverted PWM output during counting. Could imply that when stopped does not follow the line signal.

   

 

   

Bob

0 Likes
lock attach
Attachments are accessible only for community members.
Anonymous
Not applicable

Here it is.

   

PWM11 and PWM12 must be complete Invertet.

0 Likes
lock attach
Attachments are accessible only for community members.
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

Use a NOT gate as in the example.

   

 

   

Bob

0 Likes
Anonymous
Not applicable

Really good idea! Simple solution...

   

Can you help me also with this problem: 

   

http://www.cypress.com/forum/psoc-4-architecture/4200l-best-way-scan-mutiple-channel-adcsar#comment-...

0 Likes