- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I am a new user of cypress ARM.
Is it possible to use Segger J-Link with CPU FM3 MB9AFAA2N?
Could you recommend me any compiler for this CPU? I normally use Rowley Crossworks for others ARM.
Thank you very much
Halba
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Halba,
Yes ,you can use J-link to program and debug FM3 family,
Compilers recommended would be GCC,MDK .
Please check the below link for crossworks
http://www.cypress.com/design-guides/fm3-familycrossworks-quick-start-guide
But if you need Peripheral Driver Library support for 2.0.2 ,then IAR and Keil Uvision are supported only.
http://www.cypress.com/documentation/software-and-drivers/peripheral-driver-library-pdl
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Halba,
Yes ,you can use J-link to program and debug FM3 family,
Compilers recommended would be GCC,MDK .
Please check the below link for crossworks
http://www.cypress.com/design-guides/fm3-familycrossworks-quick-start-guide
But if you need Peripheral Driver Library support for 2.0.2 ,then IAR and Keil Uvision are supported only.
http://www.cypress.com/documentation/software-and-drivers/peripheral-driver-library-pdl