- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have an Evaluation board type SK-FM4-176L-S6E2CC-VOI, and I have the following issues:
1- I am using KEIL uVision 5.23 to programming into the S6E2CC, but I can not find a project file to use as a template/project files for software development using KEIL.
2- I tried to test the board by following the steps explained in 'SK-FM4-176L-S6E2CC Quick Start Guide' but I got a wrong output as shown in the attached screenshot.
I have the following softwares installed
- KEIL uVision 5.23
- Peripheral Driver Library (PDL) and the examples I found in this suite are for other boards
- CMSIS-DAP ver.14
- SerialPortViewer ver.5.8.3
Thanks
Mahmoud
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The PDL 2.1 supports S6E2CC device, (PDL-->devices-->FM4-->S6E2CCxJ) ,you need to create a project for this device.
Please refer to section 4 of quick start guide in doc folder of PDL .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The PDL 2.1 supports S6E2CC device, (PDL-->devices-->FM4-->S6E2CCxJ) ,you need to create a project for this device.
Please refer to section 4 of quick start guide in doc folder of PDL .