- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am working on power line communication on CY3274 development board , and wanted to use i2c protocol to communicate with the I/O expander but unable to implement it.The problem is the chip(i.e CY8CPLC20) is unable to generate clock on SCL pin(i.e P1[7]).
Can anyone help me to solve this problem
Regards
Shafi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shafi,
I presume you must have added an I2C Master to the PSoC Designer project. If not, you will have to create a PSoC Designer project, using CY8CPLC20 as the device, and add an I2C Master. Another possibility is that we do not have I2C pull-ups installed on the board. You can try adding pull-up resistors of 3k3 and see if you can see the clock.
Thanks and Regards,
Sampath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can see that there is a provision for pull-ups at P1.7 and P1.5. Use jumpers at JP3 and JP4. Sorry for the mistake in the prior post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sampath,
Firstly thanks for the reply,it means a lot,i will try it let you know