- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone, i'm new in cypress devices. I have a CYBLE-022001-00 and i need to connect this module to my Xilinx Zynq-7000 Board as a receiver for some data (using UART pins only).
I build, program and debug my system in Vivado Design Suite for Xilinx devices. So can I use a CYBLE-022001-00 module in my project? How I need to program and debug it? What a features and procedures?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Andrey,
Based on these requirements, you should look at the recently released EZ-Serial firmware platform for Cypress EZ-BLE modules:
http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform
This page describes the capabilities of the platform and links to a detailed User Guide with lots of reference material and examples.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Andrey,
Based on these requirements, you should look at the recently released EZ-Serial firmware platform for Cypress EZ-BLE modules:
http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform
This page describes the capabilities of the platform and links to a detailed User Guide with lots of reference material and examples.