- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any reason (other than it is damaged) for a single module to get reach IntDefaultHandler?
I have two prototypes one seems to work the other dose not. I tried to use the Find Me example (attached) with similar results.
The call stack is as follows:
0 IntDefaultHandler() .\Generated_Source\PSoC4\Cm0Start.c 123 0x000003D4 (All)
1 <signal handler called>() ?????? ?????? 0xFFFFFFF9 (All)
2 CyBLE_Bless_RfRegWrite(reg32 * blessAddr = 0x402e10d8, const uint16 regValue = 88) .\Generated_Source\PSoC4\BLE_HAL_PVT.c 300 0x0000128C (All)
3 CyBleStackMgr_SetClockParam() ?????? ?????? 0x00002B9C (All)
4 CyBleStackMgr_BleSSInit() ?????? ?????? 0x0000291C (All)
5 CyBleStackMgr_Init() ?????? ?????? 0x00001E14 (All)
6 CyBle_StackInit() ?????? ?????? 0x00001BA6 (All)
7 CyBle_Start(CYBLE_CALLBACK_T callbackFunc = 0x22d <StackEventHandler>) .\Generated_Source\PSoC4\BLE.c 477 0x0000062E (All)
8 main() .\main.c 171 0x00000306 (All)
Thanks,
S
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I tried your project on my CYBLE-022001-EVAL board and I didn't find any issues. Means firmware don't have any problem.
Are you using a custom board? If then, there could be any board issue(Please share the PCB if you want us to review), otherwise the chip may not have soldered properly/might have damaged.
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I tried your project on my CYBLE-022001-EVAL board and I didn't find any issues. Means firmware don't have any problem.
Are you using a custom board? If then, there could be any board issue(Please share the PCB if you want us to review), otherwise the chip may not have soldered properly/might have damaged.
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anjana,
Thanks for the response.
It is a custom board and the firmware works on a identical board. I was just verifying that it is a hardware problem and I am not missing something in the firmware.
Best,
S