- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm currently trying to debug a project I have/had running on the CYBLE-022001-00 PROC chip. Currently, I'm running into an issue where the debugger is crashing after some x-seconds.
Currently, I do initialization setup, call CyBle_Start(), and then sit in a while(1) { CyBle_ProcessEvents(); } loop. The debugger crashes after an inconsistent number of loops through the CyBle_ProcessEvents() function.
Has anyone else run into the process events causing the debugger to crash?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think the problem is related to the Miniprog3 that I was using; I switched to a different Miniprog3 and the issue seems to have disappeared. I will have to look into it more, but it seems like I might have damaged the programmer's functionality in some way.
Sorry for not posting this information earlier 😞
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please share your project which is failing?
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think the problem is related to the Miniprog3 that I was using; I switched to a different Miniprog3 and the issue seems to have disappeared. I will have to look into it more, but it seems like I might have damaged the programmer's functionality in some way.
Sorry for not posting this information earlier 😞
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Change the USB cable to a shorter one. That has helped some users.
Bob