Anonymous
Not applicable
Feb 14, 2017
08:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 14, 2017
08:57 AM
Is it possible to connect a I2C configured SCB Block to two different output ports?
I know it makes not much sense in terms of design, however I made a routing mistake on the PCB and now two I2C Slaves are not connected to one port but to two different ones. As I'm running out of SCB's and UDB's my only chance right now is to make a connection between the both by manual hardwires which I'd like to avoid.
In detail: I'd like to connect P7.0/P6.4 as SCL and P7.1/P6.5 as SDA on a CY8C4245AXI-M445
Regards,
Andreas
1 Reply
Feb 14, 2017
12:00 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 14, 2017
12:00 PM
SCB based components do not allow for free routing. P6_4 and P6_5 are not reachable by I2C SDA and SCL.
Bob