- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
I would like to get some SWO trace from CY8CKIT-046 PSoC® 4 L-Series Pioneer Kit. I'm Seggert jlink (ultra+) and J-link gdb server.
Is there any instructions how to configure the printf output to swo? I've checked this, but I don't have Keil or IAR workbench.:
http://www.cypress.com/knowledge-base-article/using-embedded-trace-macrocell-etm-kba90952
- Labels:
-
ispn:39616:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The article says "To use the tracing features, you must export your PSoC Creator project to one of the following third-party IDEs: "Keil or IAR". If you are not using both, which IDE are you trying to use?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to use the Seggert supplied GDB server terminal.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer the JLINK documentation : https://www.segger.com/admin/uploads/productDocs/UM08001_JLink.pdf
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Any progress on this?