Attachments are accessible only for community members.
Anonymous
Not applicable
Apr 12, 2017
12:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 12, 2017
12:14 PM
I've iterated several hardware designs but everything I try leads to a code 43 error. I'm using osh park to manufacture the boards. Using Saturn PCB design I've calculated the impedance width of 45 mil. I've included my design files. What do I need to change to get it to work appropriately?
The only time I've had any success is when I do not copper fill the entire board and route the traces without any tvs, resistors, or capactors attached. Yet without the tvs, its functionality lasted only a couple of hours before it was no longer functional. Thanks for the help.
1 Reply
Apr 17, 2017
10:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 17, 2017
10:04 AM
Hey,
Please check kit design file of CY8CKIT-046. This should be helpful . You may compare your schematic with this. http://www.cypress.com/file/341621/download