Miniprog3 Cannot Acquire PSoC

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
lock attach
Attachments are accessible only for community members.
Anonymous
Not applicable

Hello everyone.

   

I made a simple board using a PSoC 5LP. In order to program it, I planned on using the MiniProg3 with SWD over the 5-pin connector via the Reset method. However, I am unable to program the device. I have attached screenshots of the PSoC programmer and the schematic for the board. It seems like the MiniProg3 can detect the target voltage (5V), but not the target device.

   

Any thoughts are appreciated. Apologies for the messy schematic 🙂

0 Likes
2 Replies
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

How are you resetting the device see this 
For Power cycle mode Programming, XRES pin is not required. But the Host programmer must have
the capability to toggle power (Vddd, Vdda, All Vddio’s) to PSoC 5. This may typically require
external interface circuitry to toggle power which will depend on the programming setup. The power
supplies can be brought up in any sequence, however, once stable, VDDA must be greater than or
equal to all other supplies. Have you tried the Jtag programming setup?

0 Likes
Anonymous
Not applicable

Whelp the problem was just the solder connections on the header that the MiniProg3 connects to on the PCB. Everything is good to go now 🙂

0 Likes