How to program EZ-BLE PRoC Module?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
DhDa_2432241
Level 5
Level 5
5 likes given First like received First like given

Hello,

   

I am very confused with EZ-BLE PRoC and EZ-BLE PSoC modules. I have CYBLE-012011 which is a EZ-BLE PRoC module. From this page, it says that the EZ-BLE 012011 evaluation board can be programmed using Cy8CKIT-002 PSOC MINIPROG3 PROGRAM AND DEBUG KIT.

   

On the programmer, it says "PSoC Architecture Supported - 1, 3, 5". 

   

How do I know the architecture of my EZ-BLE module?

   

The programmer is for PSoC architecture. Will it work with PRoC?

   

If someone would clarify the difference between PSoC and PRoC it would be really helpful.

   

Thanks

   

Dheeraj

0 Likes
1 Solution
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

PRoCs family is basically PSoC4. The Miniprog3 is able to program PSoC 3, 4 and 5 (probably 6 when it is there).

   

 

   

Bob

View solution in original post

0 Likes
3 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

PRoCs family is basically PSoC4. The Miniprog3 is able to program PSoC 3, 4 and 5 (probably 6 when it is there).

   

 

   

Bob

0 Likes
DhDa_2432241
Level 5
Level 5
5 likes given First like received First like given

Thanks.

0 Likes
Anonymous
Not applicable

As a money-saving tip, you can program any of the PRoC or PSoC BLE modules (or chips) using the KITPROG 2 adapter that comes on many of the low-cost prototyping kits (eg CY8CKIT-043). I think these are slower at programming than Miniprog3, but they do give full programming and debug features in PSoC Creator for pocket money!

0 Likes