- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi to all,
from the p.31 of Cyalkit e-02 solar powered BLE sensor RDK guide section 3.4, the Serial Command List states that there is the ability to configure basic Eddystone parameters. By using the solar_BLE_sensor_v1.100.hex firmware it seems that only a portion of the commands recognized ([1] -[5] and [19] - [22]). Is this normal? Am i supposed to perform a special procedure in order to "unlock" the eddystone configuration service from USB?
thanks in advance
George
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Check out the project in the following link
Thanks,
Yuva.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I guess that Eddystone functions is not implemented. The sample project for the kit does not include codes to process commands used for Eddystone. Does anyone know a sample project to make the beacon to act as an Eddystone beacon?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Check out the project in the following link
Thanks,
Yuva.