Okay, still no idea what Im doing wrong. My PSCO Creator install in fine, and I am using a PSOC 5lp kit without incident. But I cannot find the files to load code onto the 4200. Can someone point me in the right direction? Thanks!
Your Kit -049 is pre-programmed with a bootloader and without a miniprog3 this cannot be altered.
When programming a bootloadable project you need to refer to the .elf and .hex files. These have been installed on your PC when you installed the -049 kit files. Look for Program files (x86)\Cypress\CY8CKIT-049-..... and descend into the shadows... mine is
C:\Program Files (x86)\Cypress\CY8CKIT-049-42xx\1.0\Firmware\SCB_Bootloader\UART_Bootloader.cydsn\CortexM0\ARM_GCC_484\Debug