Anonymous
Not applicable
May 15, 2017
02:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 15, 2017
02:48 AM
hello,everyone,
I transfer several data to the pc,and I use the "control center" to do this,but when I open the file ,it shows some error codes?Is it ASCII code or string ? Does it show the data correctly ? Or does it only show in this way?Thank you!
regards,
Alex
2 Replies
May 15, 2017
10:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 15, 2017
10:32 PM
Hi Alex,
The Control Center stores the hex values coming form FX3 as is into a file. You can open the saved file using any hex editor software and you should be able to see the data sent by FX3.
Thanks
Manas
May 15, 2017
11:49 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 15, 2017
11:49 PM
ok,thank you very much ,Manas