How to disable Kitprog's Mass Storage mode?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hi.

   

I use the Kitprog as a programmer for my board. Occasionally, when plugging the Kitprog to the PC, it doesn't automatically recognize the target, and goes into the Mass Storage mode.

   

Is there a way to disable this mode? I want the Kitprog to connect itself only as a "normal" programmer/debugger. This "5 seconds reset button hold" drives me crazy...

   

Thanks.

0 Likes
3 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

In Kitprog manual is written to press the switch for more than 5 seconds to change the mode.

   

 

   

Bob

0 Likes
Anonymous
Not applicable

That's exactly what I'm trying to avoid, because many times happen that I disconnect the Kitprog from PC, then connect it again, and it shows again as Mass Storage. So again I need to press for 5 seconds.

   

I want to disable this mode permanently.

0 Likes
AnkitaS_51
Employee
Employee
100 likes received 50 likes received 25 likes received

You can't disable the mass storage mode from current version of Kitprog.You can go to older version of Kitprog, for that you have to  upgrade Firmware of Kitprog using older version of PSoC Programmer.

   

But ,it is always recommended to have newer version for improved software.

0 Likes