- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
I use the Kitprog as a programmer for my board. Occasionally, when plugging the Kitprog to the PC, it doesn't automatically recognize the target, and goes into the Mass Storage mode.
Is there a way to disable this mode? I want the Kitprog to connect itself only as a "normal" programmer/debugger. This "5 seconds reset button hold" drives me crazy...
Thanks.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In Kitprog manual is written to press the switch for more than 5 seconds to change the mode.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That's exactly what I'm trying to avoid, because many times happen that I disconnect the Kitprog from PC, then connect it again, and it shows again as Mass Storage. So again I need to press for 5 seconds.
I want to disable this mode permanently.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can't disable the mass storage mode from current version of Kitprog.You can go to older version of Kitprog, for that you have to upgrade Firmware of Kitprog using older version of PSoC Programmer.
But ,it is always recommended to have newer version for improved software.