- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Respected All,
I am working on Project based on CY8CMBR3102 capsense application , to configure this device I want to connect EZclick 2.0 software to device over I2C protocol. I have purchased UMFT201XA USB to I2C converter from FTDI .please guide me how to proceed for configuring device.
Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the MBR3 capsense design guide document. In the section 5.2 Configuring CY8CMBR3xxx you will find the details about different ways of configuring MBR3 device.
http://www.cypress.com/file/46366/download
Thanks,
Ranjith
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the MBR3 capsense design guide document. In the section 5.2 Configuring CY8CMBR3xxx you will find the details about different ways of configuring MBR3 device.
http://www.cypress.com/file/46366/download
Thanks,
Ranjith
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply,but I want to know how to interface UMFT201XA USB with EZ CLICK2.0