Jun 12, 2017
11:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2017
11:45 PM
Hi sir,
I found Capsense component do not have hardware pin output and the logic AND cell do not have APIs function,so how can I connect them each other for some application needed?
Chris
5 Replies
Jun 12, 2017
11:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2017
11:50 PM
What about ANDing in software?
Bob
Jun 13, 2017
12:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 13, 2017
12:37 AM
Hi Bob,
My application like this:
Using 10 Capsense buttons to control 10 LEDs switch on/off respectively,and the 10 LEDs lightness can be adjusted by a PWM component,so I need logic AND in hardware.
Chris
Jun 13, 2017
01:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 13, 2017
01:02 AM
Then you will need to use a CY8C42xxx which has got some extra logic resources.
Bob
Jun 13, 2017
02:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 13, 2017
02:31 AM
Ok,thanks Bob,I will try to upgrade it.
Jun 13, 2017
06:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 13, 2017
06:28 AM
You can start by setting the device in your project to a 42xxBLE device and look at the digital components then.
Bob