- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I'm having a very strange problem with scanning for advertising devices
I modified the Observer project (Day 10 )for my hardware
While I;m 100% certain that there are devices advertising, ( CySmart sees them the CYBLE_EVT_GAPC_SCAN_PROGRESS_RESULT event never fires!
And the strangest thing is that it was working yesterday!.
I was at a different location but other than that nothing is different.
Project is attached. It's just a sample from the 100 series - I only disabled the low power mode stuff and the UART
Any ideas? I'm at my wit's end
One thing that appears strange to me
In the file BLE_eventHandler.c in the case CYBLE_EVT_GAPC_SCAN_PROGRESS_RESULT the code only executes when CYBLE_CPS_CLIENT is defined. It is not defined for this project . Any details on that ?
Thank you
Andy
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Never mind.. operator error. In the other location the distance between the tags was over 3 meters and there were some metal obstacles.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Never mind.. operator error. In the other location the distance between the tags was over 3 meters and there were some metal obstacles.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welp; Glad we could help you out 😉
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks 🙂
I still have an outstanding issue not related to this, that I'm struggling with
Would appreciate some help
http://www.cypress.com/forum/proc-ble/piezo-beeper-setup?page=1
Thanks
Andy