- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I wanted to ask on the what is the difference of this IC which is made by FUJITSU and Cypress?
How can i program this MCU's by RS232C or JTAG?
If there is any special cable used, what is it?
I tried to flash it using Cypress Flash USB Direct Programmer. When flashing, it says success, when i checked its not working.
I do use Superpro programmer and it was working, but for some reason USB flashing could be fast and easy.
Any ideas?
Thanks
Rey
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
What is the hardware you are using ?
Section 9 explains the hardware connections required , you can also refer the same in chapters 3,4 in the User manual of FLASH USB DIRECT Programmer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
this forum is dead?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
What is the hardware you are using ?
Section 9 explains the hardware connections required , you can also refer the same in chapters 3,4 in the User manual of FLASH USB DIRECT Programmer.