Anonymous
Not applicable
May 24, 2017
03:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 24, 2017
03:55 AM
I am designing a rigid-flex board with the FX3 Super Speed controller.
Is it possible to route the 9 USB 3.0 lines on Kapton before reaching the USB standard connector? Is there any extra rule that I need to follow in this particular case other than matching the 90 Ohm specification for the impedance?
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Jun 16, 2017
10:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 16, 2017
10:00 AM
Hi,
Please make sure that by any chance, there will be no difference in lengths between the different USB 3.0 trace lines (especially when bent).
Regards,
- Madhu Sudhan
1 Reply
Anonymous
Not applicable
Jun 16, 2017
10:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 16, 2017
10:00 AM
Hi,
Please make sure that by any chance, there will be no difference in lengths between the different USB 3.0 trace lines (especially when bent).
Regards,
- Madhu Sudhan