I programmed my tiny dev board for the first time using the bootloader host and now the board blinks fast when i plug it in. I cant seem to program it any more either. I followed the instructions on the PDF too.
Okay so Just to check you have pressed the switch before you plugged in the board. If you did then you will need to follow this example http://www.cypress.com/knowledge-base-article/using-cy8ckit-049-program-another-psoc-4-kba93541 and also purchase another cy8ckit-049 board or you will need a MINIProg 3 to reload the software. This example is the cheapest way to go. Or you could purchase this CY8CKIT-043 PSoC 4® M-Series Prototyping Kit it is a lot easier to use.
