Apr 10, 2017
09:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 10, 2017
09:38 PM
I programmed my tiny dev board for the first time using the bootloader host and now the board blinks fast when i plug it in. I cant seem to program it any more either. I followed the instructions on the PDF too.
1 Reply
Apr 11, 2017
06:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 11, 2017
06:45 AM
Okay so Just to check you have pressed the switch before you plugged in the board. If you did then you will need to follow this example http://www.cypress.com/knowledge-base-article/using-cy8ckit-049-program-another-psoc-4-kba93541 and also purchase another cy8ckit-049 board or you will need a MINIProg 3 to reload the software. This example is the cheapest way to go. Or you could purchase this CY8CKIT-043 PSoC 4® M-Series Prototyping Kit it is a lot easier to use.