CYBLE-214009-00 EZ-BLE Module Programming Issue

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
GyanC_36
Employee
Employee
250 replies posted 100 replies posted 50 replies posted

Hi,

   

  I currently have a CYBLE-214009-00 on a custom board, when power is added as seen in the datasheet, I don't pick up a bluetooth signal on another device. Is programming to the module required? if so how can i program this module?

   

Thanks,

   

Nicolas

0 Likes
1 Solution
GyanC_36
Employee
Employee
250 replies posted 100 replies posted 50 replies posted

Hi Nicolas,

   

The module CYBLE-214009-00 should come pre-programmed with EZ-Serial firmware ( If module shipped (from our factory) after 1/1/2017) and should be advertising by default. If the module was shipped from older inventory shipped previously, then it would not be. You can download the firmware image from the below link. http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform

   

Regards,

   

Gyan​
 

View solution in original post

0 Likes
1 Reply
GyanC_36
Employee
Employee
250 replies posted 100 replies posted 50 replies posted

Hi Nicolas,

   

The module CYBLE-214009-00 should come pre-programmed with EZ-Serial firmware ( If module shipped (from our factory) after 1/1/2017) and should be advertising by default. If the module was shipped from older inventory shipped previously, then it would not be. You can download the firmware image from the below link. http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform

   

Regards,

   

Gyan​
 

0 Likes