- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've added 25 buttons in a single Capsense P4. Is it too many buttons? It shows the below error.
The assignment for pin "\CapSense:Sns(10)\" requires CSD block "\CapSense:CSD\" to be locked to F(CSD,0), but another pin assignment requires that it be placed in F(CSD,1)
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I hope you are using PSoC 4M Capsense component.In the architectural TRM you can see "The port 5 pins are hard-coded to the CSD1 block and therefore, cannot be controlled by the CSD0 block. The CSD0 block can be connected to all pins except port 5."
That is causing the issue.
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which device do you use? Please attach your project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I hope you are using PSoC 4M Capsense component.In the architectural TRM you can see "The port 5 pins are hard-coded to the CSD1 block and therefore, cannot be controlled by the CSD0 block. The CSD0 block can be connected to all pins except port 5."
That is causing the issue.
Best Regards,
VSRS