- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
Created a sample project to dump trace information on timer call back . (modified one of the WICED application sample)
- When the firmware is uploaded to Development board CYW20737_LE_TAG4. I could seen periodic trace message printer through debug port.
- Whereas when same program dumped on to a custom made applicaiton board. The execution stops after "create()" function.
Attahced firmware upload log and trace dump from both Development board and Custom board.
Could I please have suggestions/overview on this?
thanks and regards
Haric
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I assume you are using the 20736S SIP module.
Can you check the below entry in your cgs file?
ENTRY "PMU Crystal Warm up Time"
{
"Crystal warm up time" = 5000
}
Is it 5000?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I assume you are using the 20736S SIP module.
Can you check the below entry in your cgs file?
ENTRY "PMU Crystal Warm up Time"
{
"Crystal warm up time" = 5000
}
Is it 5000?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Perfect!, Thanks for your suggestion,
I had tried with "Crystal warm up time" = 5000
and code gets executed.