Attachments are accessible only for community members.
Anonymous
Not applicable
May 04, 2017
05:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 04, 2017
05:47 AM
Dear support,
I have a problem with the debugger not working.
I use an eval board MurataType1LD, It is a combo wifi /ble.
I use WICED studio 4.1 and 43xxx_WiFi SDK.
I use the the following target : xxx-MurataType1LD-debug download
The download work. After I clicked on the start debug, I go directly to hard fault handler (see in the enclosed file).
Does it do a specific configuration for the debbugger?
Does it do add a specific command in the makefile or in the program?
I configured the debbugger exactly as the documentation(see in enclosed too).
1 Reply
Attachments are accessible only for community members.
Anonymous
Not applicable
May 04, 2017
05:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 04, 2017
05:49 AM