Anonymous
Not applicable
Apr 01, 2014
06:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2014
06:15 AM
Hi,
any suggestion to interface analog signals with range from 0 to 5V with BCM20732 AD channels that must work on range 0 to 3.3V?
Thanks,
Fernando.
Solved! Go to Solution.
1 Solution
Apr 01, 2014
11:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2014
11:38 AM
3 Replies
Anonymous
Not applicable
Apr 01, 2014
10:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2014
10:41 AM
Hello Fernando,
Please check out the following posts to get you started:
Re: BCM20732S ADC Configuration
Re: BCM20732S Electrical Spec - Interfacing to Higher Voltages
Let me know if you have any questions after looking at these.
JT
Apr 01, 2014
11:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2014
11:36 AM
Hi J.T
Thank You very much by your reply.
OK, after reading it doubts clarified.
I decided to use external 2 channel 5V SPI AD to measure sensor needed (car throttle pedal - analog signals POT1 and POT2 range 0-5V).
Best Regrads,
Fernando.
Apr 01, 2014
11:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2014
11:38 AM
Ok, great!
Let me know if you have further questions.
J.T