- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In bcm43455 FW, I would like to adjust threshold of Adaptivity active, transmission stop by this level.
Current parameter is below
eu_edthresh2g=-65
eu_edthresh5g=-65
This information is descrived in nvram_ap6255.txt, at /mnt/mtd.
These value are only avalilable -75 to lower, -75dBm MAX.
If I set threshold value is -65dBm by "eu_edthresh2g=-65", adaptivity active level is still -75dBm.
Could somene instruct how to adjust threshold AND are there any other parameter to enable threshold?
Thank you
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: How to disable Adaptivity function in bcm43455?
Per the other three posts on the same/similar subject, please reach out to USI.
I will also ask the Linux team in-house if there is any non platform specific guidance they can provide in this area: seyhan vsb
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you!!
I really need guidance to be available adaptivity threshold parameter.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I got proper parameter, thanks!