Threshold of Adaptivity is not working

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
YuSu_2202696
Level 1
Level 1

In bcm43455 FW, I would like to adjust threshold of Adaptivity active, transmission stop by this level.

Current parameter is below

eu_edthresh2g=-65

eu_edthresh5g=-65

This information is descrived in nvram_ap6255.txt, at /mnt/mtd.

These value are only avalilable -75 to lower, -75dBm MAX.

If I set threshold value is -65dBm by "eu_edthresh2g=-65", adaptivity active level is still -75dBm.

Could somene instruct how to adjust threshold AND are there any other parameter to enable threshold?

Thank you

0 Likes
1 Solution
MichaelF_56
Moderator
Moderator
Moderator
250 sign-ins 25 comments on blog 10 comments on blog

Per this response, please reach out to USI for support: Re: How to disable Adaptivity function in bcm43455?

jone

View solution in original post

0 Likes
1 Reply
MichaelF_56
Moderator
Moderator
Moderator
250 sign-ins 25 comments on blog 10 comments on blog

Per this response, please reach out to USI for support: Re: How to disable Adaptivity function in bcm43455?

jone

0 Likes