Aug 01, 2016
04:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2016
04:20 PM
1 Solution
Aug 01, 2016
04:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2016
04:21 PM
In order to prevent UART data loss while asleep we recommend that flow control lines (RTS and CTS) are used to allow the chip to wake up and assert clear to send prior to transmission.
This is specifically suited for the case of an HCI UART device attempting to send data to its host CPU.
2 Replies
Aug 01, 2016
04:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2016
04:21 PM
In order to prevent UART data loss while asleep we recommend that flow control lines (RTS and CTS) are used to allow the chip to wake up and assert clear to send prior to transmission.
This is specifically suited for the case of an HCI UART device attempting to send data to its host CPU.
Aug 29, 2016
12:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 29, 2016
12:17 AM
Hi jankewtorres
BTW, Should we don't use flow control lines to do this thing? just only use Uart TX and RX. The hardware also disable flow control lines on the host board.