- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello vsb
Based on your answers provided in the other thread, for which I am thankful for, I have additional questions:
In the imx6ul-evk-btwifi.dtsi file, it mentions in the comments that
" This DTS file is written for plugging in Murata Wi-Fi/BT EVK into Slot * SD1 and using Murata i.MX InterConnect Ver 2.0 Adapter. Bluetooth UART & control signals are connected via ribbon cable (J1701 connector)."
However, I've noticed that the pin control for wlreg_on is
gpio5_1 [
MX6UL_PAD_SNVS_TAMPER1__GPIO5_IO01]
which is not wired to imx6ul-EVK J1701.
Can you elaborate on how the 4343 WLREG_ON is controlled?
- Is WL_HOST_WAKE requied for the bcmdhd driver.
Thanks in advance for your help.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Some hardware modifications are required for OOB operation on iMX6UL which requires WL_HOST_AWAKE to be hooked up.
But these modification are not required for non OOB operation, which is the default mode of operation.
The modification required are mentioned in "Murata Wi-Fi/BT EVK for i.MX6 Hardware User Manual 1.0 ". After you register with Murata you can get them at:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Some hardware modifications are required for OOB operation on iMX6UL which requires WL_HOST_AWAKE to be hooked up.
But these modification are not required for non OOB operation, which is the default mode of operation.
The modification required are mentioned in "Murata Wi-Fi/BT EVK for i.MX6 Hardware User Manual 1.0 ". After you register with Murata you can get them at: