- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm trying the snip.sd_filesystem application. in Wiced Studio 6.4 with my working board and a 8GB SD Card.
My working board was made based Murata 1GC board (CYW943907AVAL1F).
I think, this has became correctly to detect a SD Card.
But, the errors occur.
Also, I have cypress board and I'm trying the snip.sd_filesystem application. this works normally.
I attached log file.
thanks and regards
Solved! Go to Solution.
- Labels:
-
Debug
-
GPIO
-
Interrupts
-
Memory
-
PCBLayout
-
WICED Studio
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I would suggest getting the schematics to check from the module vendor if the board is custom designed. We can then isolate the issue to the application/software then.
Thanks
Aditi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Is your board custom designed? If yes, can you provide more information on your custom designed board?
If possible, provide the schematics to us to better understand the issue.
Thanks
Aditi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, it's custom design.
My working board was made based Murata 1GC board (CYW943907AVAL1F).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I would suggest getting the schematics to check from the module vendor if the board is custom designed. We can then isolate the issue to the application/software then.
Thanks
Aditi