- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I see that the SCB in UART mode can be set up to talk to an SD Card in ISO7815 mode. I want to put it on product that plugs into and Smart Card slot so I want it to act like an SD Card.
Is that possible?
This is a PSOC6 application.
Best Regards,
Mike Roberts
Arrow Infineon Specialist
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mike,
It should be possible.
Here is a link to a previous discussion about the HW resources needed on a PSoC6.: PSoC62 UART smartcard mode
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mike,
It should be possible.
Here is a link to a previous discussion about the HW resources needed on a PSoC6.: PSoC62 UART smartcard mode
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That is for PSOC Creator. Is there a way to do this in Modus Toolbox?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mike,
Yes. However since Cypress didn't support UDBs and routing through a TopDesign method it will be a little more challenging and more limited.
Len
"Engineering is an Art. The Art of Compromise."