- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi all ,
this is arul ,am very new bee for psoc and I have knowledge in pic and arm (u vision). last week I bought CY8ckit-042-BLE and downloaded and installed the psoc creator 4.3.
firstly i just create simple led blink project with below steps and i try to upload to kit but i cant so please kindly some one advise me how i upload the code to kit.
steps i followed :
1. new project
2.selet empty schematic>target -4200 ble >entered project name .
3. in the schematic file i created a new output pin .
4. connect the pin into ic design .
5.main file just toggle the output with delay
6.click build button and its compiled successfully.
7. i connect my kit using usb and click upload button but the program not upload .
here i attached some reference image .please kindly some one help me to resolve this thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
arm,
Hi. Forgive me for asking this silly question:
Is the smaller plugin board installed on your kit?
You could be getting the responses you are seeing this this board is not installed or installed incorrectly.
Also, make sure that the jumper on J15 is present.
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You can use the PSoC Programmer to program your project where you can upgrade the firmware also.
Below is the link to download the PSoC Programmer.
https://www.cypress.com/products/psoc-programming-solutions
Regards
Alakananda
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Alakananda,
thank you so much for your kind reply .i downloaded the psoc programmer and installed and then i select hex-file from the project folder and click upload but i got programming field .please kindly help me advise me to resolve this .
i hope i will get a reply from you very soon .
Thanks ,
Arul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you refer to the below KBA, which will help you solve your issue.
Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619
Regards
Alakananda
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
arm,
Hi. Forgive me for asking this silly question:
Is the smaller plugin board installed on your kit?
You could be getting the responses you are seeing this this board is not installed or installed incorrectly.
Also, make sure that the jumper on J15 is present.
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
dear len,
yes, it's installed .and thanks for the reply I managed to upload the code successfully. I press the reset button a few times and remove the BLE module and insert again after that I successfully uploaded the code.
thanks a lot for your valuable replies and if I face any programming error or difficulty in the future I will raise a quarry.
Thanks,
Arulchozhan