- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
I'm trying to modify the example project in the GPIF-II designer such that I can send it a signal to the GPIF-II state machine to send an interrupt to another chip via the INT pin. The problem I'm running into is that when I try to build the state machine into a header file, I receive "Build failed due to errors" in the output log, but no other error messages.
I'll attach my project so you can take a look.
If you have any insight into the problem, or any other useful information, I'd love to hear it.
Best Regards,
Thomas
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tomas,
In GPIF II designer, each transition equation is limited to the use of four (or fewer) trigger variables. This limitation can be surmounted by using mirror states.
Please get more details from section 4.5 of GPIF II designer user guide.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tomas,
In GPIF II designer, each transition equation is limited to the use of four (or fewer) trigger variables. This limitation can be surmounted by using mirror states.
Please get more details from section 4.5 of GPIF II designer user guide.
Regards,
Eddie