- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,Area need to understand: Setting flash address and parity bit
I have tried to set Code flash ECC using fault injection concept. I referred Family architecture TRM and Register TRM.The information is not sufficient to set 2bit ECC of code flash.can you provide ECC fault injection user manual for cyt2b9-series or please support me via call/mail?For me flash address bit fall above 24bit .if take device address some address bits are lost to set in register.and want to understand how 8bit parity is inserted to trigger 2bit ECC.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please kindly get in touch with your Cypress contact window for this question on Traveo II as the complete documentation is not public yet.
Kind Regards,
Yuva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please kindly get in touch with your Cypress contact window for this question on Traveo II as the complete documentation is not public yet.
Kind Regards,
Yuva