- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using a RS232 FTDI adapter to download a hello_sensor_app through the HCI interface. The communication goes fine and the minidriver is launched OK but the log file shows the module memory has a mistmatch in the bytes writen and read.
I append here the last lines of the log:
A total of 2 contiguous memory areas were filled:
[FF000000..FF000027] DATA (40 bytes)
[FF003000..FF01419B] DATA (70044 bytes)
Download config error trying to verify 40 bytes at address 0xFF000000 (SOURCE: CONFIG Configuration data build/hello_sensor-CYBT_343026_EVAL-rom-ram-Wiced-release/hello_sensor-CYBT_343026_EVAL-rom-ram-Wiced-release.hex) (Data mismatch at address 0xFF000000. Expected byte value 0x01 but device contains 0x66)
Please, help.
Thanks,
- Tags:
- cybt-343206-01
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi PeDo_4684411,
Have you made any changes in .btp file or configuration files? Are you able to program the board using WICED IDE? Can you please attach full log of the error?
Make sure you have sent reset command initially and board is in download mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sheetalj_96.
I have not made any change in those files you mentioned. I have follow the instructions as indicated in KBA223428. The platform files used and modified as instructed in KB221025. I am using the last WICED Studio version available. I have no problems for initiating the downloading process as you can see in the log file attached after a Recovery Procedure.
Thank you in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sheetalj_96.
I have asked for a solution to a downloading problem related to a custom card that embed a CYBT-343026-01. The log file that demonstrates a good communication between the Wiced Studio and the module in the card have been sent without an answer. The log shows also that the problem occurs when reading the Flash. Can you help me or this is a failure associated to the module and the inversion I did to produce the cards is lost?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Due to the lack of vital information, this issue cannot be processed.
It's recommended that you look for field debug assistance or share your whole source code, for resolving your issue.
This thread is now closed. You are always welcome to post new issues in our community.
Best regards